The information on the web page was very helpful. I assume using those
concepts and measuring where the holes are that it would not be to
difficult to figure out the widths of the boards for my 59 Fleetside
(The originals are long gone). However,...is there a listing of the
widths for a 59'?
Paul Frew
Toronto
59 Apache Fleetside, 1/2 LB
Terry Stellman wrote:
>
> Bill,
>
> Here is an old message I had saved.
>
> Terry Stellman
> 1949 3600
> Missouri City, Texas
>
> I have received a question about the purpose of the deeper groove in the
> bedwood. Rather than try to explain it with words, I found a picture
> showing how the metal wear strips sat in the grooves in the bedwood. I
> have added that picture to my bedwood page and hope that it will clear
> up any confusion. As I stated on the web page itself, if you are serious
> about rebuilding your bed, the "Bed Restoration Manual" from most of the
> ole truck vendors is a very good $4-$5 investment. Just in case you
> didn't bookmark it
>
> http://www.chevytrucks.org/users/jeff/bedwood.htm
>
> Jeff Nelson
> Paducah, KY
> 1953 3600
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|