Re: [oletrucks] Removing clutchhead screws

[Gordon Groves <ggroves100@earthlink.net>]

I have a hex bit holder that fits on my 3/8" drive ratchet and I got a
set of clutch head bits from "Snap On" using the ratchet makes it a
little easier to press the bit into the clutch head screw while using a
little leverage provided by the ratchet .

A top notch penetrate like PB laster or Aerokroil with also make a
difference.

Gordon Groves
'51 1/2 ton chevy
'54 IHC Travelall

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959