> I did get a clutchhead bit to work on those. I twisted several screws
>off so be careful.
I have had some luck with using a reversing drill where the screw heads have
come off. If you can get to the back of the part, and if the screw shafts
are long enough or if you can weld on an extension, chuck the drill onto the
screw and put it in reverse and the screw shaft will come through.
Regards,
Grant S.
54 3100 (mostly all there)
54 3100 (mostly not there)
55 1st 3100 (mostly rust)
Los Angeles, CA
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|