did you try napa or king bearing? in my book , it shows a 2791a and it has
35.707 mm bore. width of 25.654mm and a max width fillet radii of 1.5 I used
the metric measurements, because its easier to measure close tolerances in
millimeters rather than fraction of an inch with a ruler. Besides, who ever
invented the inch system is a moron. metric is so much easier.
"John B. Mercier" wrote:
> Hi folks, I have a '50 GMC 2 1/2 ton. I need new wheel bearing seals but
> nobody can even find new bearings much less the seals. My bearings are:
> timken 2791-a inside ,and 1784-a on the outside. It looks like on the
> inside I have 2 seals for the bearing and then a larger cover that goes
> over the whole assembly. One of mine is missing. Critical piece? Anybody
> out there have any info that can help me? Thanks,
> John
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|