At 08:16 AM 7/26/2000 -0500, Hanlon, Bill wrote:
>Your guess is right. That is the job of the wedge.
>The trick, at least if you have a Hydra-Matic, is
>figuring out how to tighten the screw. There is
>very little clearance between the head of the screw
>and the gizmo that indicates N-4-3-2-R to get a
>screwdriver into. I replaced the screw with a allen
>head bolt and cut off an allen wrench real short
>to do the job. Floor shift? No problem. Probably
>OK with 3 on the tree also.
Bill,
Thanks for the prompt answer. I have 4 on the floor, so should be
OK. I've a local supplier, and was going to pick up several things this
weekend, so I'll just add that to the list.
Thanks again,
Michael Keele
'55 3100 2nd (DRUID)
Denver
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|