You can't mix and match 216 and 235 exhausts and intakes. You can however bolt
the
235 assy. to a 216 but this will not allow you to use the intake alignment
inserts.
I have manifolds (too many) if you are looking to buy one.
Grant,
50 Chevy 3100
52 GMC 150
51 GMC 250
"Radicic, Gary" wrote:
> All,
> Question. Will an exhaust manifold off a 55 235 cu engine fit a 50 216. As
>far
> as I can see the exhaust sn is 3835587... and is attached to an intake sn
> 3835590.
>
> If not, it's for sale.
>
> Thanks,
> Gary
>
> Gary Radicic
> 1950 Chev 3604
> Geneseo, IL
>
> -----Original Message-----
> From: Wayne Osborne [mailto:wayne@chevytrucks.org]
> Sent: Friday, July 21, 2000 12:47 PM
> To: Ronald Tofani
> Cc: oletrucks@autox.team.net
> Subject: Re: [oletrucks] wheel striping and new hubcaps
>
> Ron,
> Are ya wanting to pin strip in with tape or with paint/brush. Just a
> thought, if ya using paint, why not place the wheel on a vehicle-jack it up
> and give the wheel/tire a spin-the hold the paint brush very still and this
> way you'll get a very round pinstrip by letting the wheel do the work
> instead of your hand.. wayne
>
> At 12:32 PM 7/19/00 EDT, you wrote:
> >Help...
> >Anyone out there have a method of pin striping wheels that works or do I
> >look for a sign painter?
> >
> >My other question is to do with purchasing new repro hubcaps for my 54
> >pickup/ Are any of these better than others?
> >
> >Thanks much..
> >Ron Tofani
> >________________________________________________________________________
> >
> >oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
> Wayne Osborne
> 1956 Chevy Pickup
> LaGrange Ga.
> http://www.chevytrucks.org/users/wayne
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|