RobXR250@aol.com wrote:
> How do you remove the driveshaft from a 50 3100 3spd tranny? Ive got the
> collar/seal thing unbolted and slid as far back on the driveshaft and also
> have unbolted the bolts that hold it to the crosmember. This is my last
> problem before i take the six out and put in the 350/350.
>
> TIA,
> Rob
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
Undo the 4 bolts that hold the actual u-joint together, then slide the rear
half back down the tube. That should give you just enough room to drop the
torque tube down.
--
Alan & Karen Gingles
Calgary, Alberta
Street Rods and other Hobbies
http://www.nucleus.com/~agingles
Alan's Hot Wheels Heaven
http://www.nucleus.com/~agingles/ALAN6.HTM
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|