Hi All,
Well I am finally getting the exhaust system installed on my truck and then
I will be about ready to start it up for the first time since the engine
was rebuilt. I have a couple of questions regarding initial startup.
1. What is the minimum wiring that I need to start and run the engine. I
will only be running it for a short time to check things out.
2. I used assembly lube when it was reassembled. Is there anything I
should do before starting the engine besides spinning the oil pump through
the distributor hole. I was planning on doing this with an electric drill
or is hand spinning with a screwdriver sufficient.
I will be adding a few new pictures of my progress to my website early next
week. In the meantime I did update the site with a few pictures of my 32
Chevy Roadster, progress pictures of my 64 Corvair Spyder Convertible, and
a new page showing all of the license plates for my vehicles.
Website is: http://www.angelfire.lycos.com/mi2/jrvvehicles
Later,
Jim V.
1958 GMC Suburban Carrier Pickup (Cameo style) - V8 Automatic
http://www.angelfire.lycos.com/mi2/jrvvehicles
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|