Tom:
Yes, it can be sanded and any paint will do. I used lacquer for
mine. JB Weld works good too. Let it dry well before sanding
though because it will continue to shrink for a while.
Joe
On 10 Jul 00, at 13:51, tcape wrote:
> NM Jim, after the epoxy sets up for a day or two......what then? Can it be
> sanded down to blend in with the wheel? And how about painting the steering
> wheel.....special paint needed....or will any paint do? Thanks for the
> help!
> Tom Caperton
> 47-2nd 3100....in Whiteville, NC
>
> ----- Original Message -----
> From: New Mexico Jim <ADvent@thuntek.net>
> Cc: <oletrucks@autox.team.net>
> Sent: Monday, July 10, 2000 12:25 PM
> Subject: Re: [oletrucks] Steering wheel gunk
>
>
> > That stuff is a rip-off. Get some epoxy from Home Depot or similar place.
> Use a
> > hacksaw blade only (no blade holder) and cut down to the steel core all
> around.
> > Make the cut wide enough to force the epoxy into the new cut. Let it set
> for a
> > day or two in a humid environment.
> >
> > Thom Laybourne wrote:
> >
> > > Old plastic does that. Contact Banjo steering wheels, don't know their
> web
> > > address, they have covers and epoxy to solve this problem.
> > >
> > > thom
> > >
> > > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
>
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
Joe Clark
'50 3100 Deluxe
Knoxville, Tennessee
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|