the pickup 5 bolt pattern is the same as a full size GM car. the trans am is a
mid size. i would run the same on all four corners. uni-slot wheels look goofy
and are not safe in my opinion. drilling is expensive, so why not make it match
with factory parts?
Mark Self wrote:
> I'm putting a '73 C-10 frontend and '79 Trans Am posi rearend under my '55
> 1st. The lugs are different sizes. The fronts are larger dia.
>
> Question: is it a reasonable project to have the holes in the rear axles
> drilled out and have lugs from the C-10 pressed in, or is it just better to
> run 2 sizes of lug nuts?
>
> Thanks in advance
>
> ====================
> Mark Self
> Redlands, CA
> '55 1st 5-window 3100
> "Sentimental Journey"
> ====================
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|