Where does air enter the system to replace that being draw into the intake
through the PCV valve? Does it have a filter.
Thanks
Eric St.Phillips
----- Original Message -----
From: <ADvent@thuntek.net>
Cc: <oletrucks@autox.team.net>
Sent: Wednesday, May 24, 2000 5:31 PM
Subject: [oletrucks] PCV Pic
>
>
> This is a PCV for the old six. It routes over the rocker arm cover and
attached
> to the port where your vacuum wipers go. I got my vacumm fitting from my
two ton
> and screwed it into same port for the vacuum wipers. The inside diameter
should
> be about 3/8ths inches or larger. The tiny wiper vacuum port will not get
it. It
> needs to be able to move a large quantiy of gases to work correctly. You
could
> just cut a hole in the top of your draft tube and install a grommet and a
PVC
> valve and route it like the original. The down tube insn't that hard to
remove
> and then just plug that hole.
> here is a pic
>
> http://www.thuntek.net/~advent/pcv.jpg
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|
