Antonio, I have one of those 99 dollar harnesses. Fir the money, you can't beat
it. I bought one for my 50, but might use it in my 51 dump truck and make my own
for the 50 . It would cost way more bucks to buy one like I am going to make.
More bucks than I have. The 49 Chevy had a fuse block. The wires are a little
thing. But it would be adequate.
new mexico jim
"Antonio R. Tijerino" wrote:
> I am ready to start putting the wiring on my truck and I am trying to decide
> how to go about installing the wiring and what to use.
> EZ Wiring kit: too expensive.
> Ron Francis kit: way too expensive.
> Painless wiring: too expensive.
> Make my own: too messy.
> Chevy Duty own kit: $99.99 reasonable.
>
> My idea is to get the Chevy Duty kit wire the truck and them get a Fuse
> Block from modern Chevy vehicle and adapt to wiring harness. EZ wiring has a
> fuse block with flashers and the other stuff for about $80.00.
>
> What are your opinions and suggestions?
> Can the two items be mixed?
> Has anyone had good/bad experience with the Chevy Duty kit?
>
> Thanks,
>
> Antonio
> '53 3100
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
--
New Mexico Jim
50 3100 ½ ton
51 6??? two ton dump
54 two ton for parts
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|