Jim:
I've gotten used to my Sears Craftsman electric right angle job. Been using it
steadily for 3 years
with no problems. It's not the easiest switch to use, but I'll think of
replacing it with maybe a
different model when it wears out. I bought a high speed straight cut-off
grinder from Harbor
Freight, it was a McCulloch model. I use it with the thin cut-off wheels for
sheet metal trimming.
It runs at 27,000 rpms and really has plenty of moxie. I think I paid about
$60 for it. It's a bit
long, about 12" in length so it won't get into those tight places. I've got an
air compressor, but
using grinders steadily eats up a lot of air and your compressor will be
running constantly, unless
you've got a decent size unit (240 volt).
Wally
> I am in the market to finally purchase a right angle grinder for use in the
> restoration of my vehicles. It won't get the kind of usage a body shop
> would use, but I want a good one. The first decision I need help in making
> is whether to go electric or air. I am leaning towards air but would like
> to hear pros and cons regarding this.
>
> The other question is more subjective. What brand and model should I be
> interested in?
>
> Thanks in advance for all comments.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|