The other cure for a gauge that reads a little to high or low is to bend
those little tabs that the float arm contacts. That will reduce or increase
the resistance signal sent to the gauge!
Joe
----- Original Message -----
From: G. Simmons <gls@4link.net>
To: brad kyle <bradkyle@hotmail.com>; <OLETRUCKS@autox.team.net>
Sent: Wednesday, February 02, 2000 9:45 AM
Subject: Re: [oletrucks] gas guages
> On mine, the new 12 v gauge read extra full all the time. As someone
elsde
> recently mentioned, the cure is to change the resistor on the sender to 90
> ohms. The original 30 ohm resistor lets too much signal pass for a modern
> gauge.
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|