Good point, although the pickup tube is centered squarely on the tank - but
I can still get the sending unit (rather the float itself) closer to the
center than the sides.
Yes, I have a new gauge also, however, the sending unit was made to fit the
stock tank so I'm having to mod it a little to fit the dimensions of the new
tank (not as tall).
Bob Welch
56 Cameo
55 Belair
----- Original Message -----
From: "J Forbes" <jforbes@primenet.com>
To: "Old Trucks List" <oletrucks@autox.team.net>
Sent: Tuesday, January 25, 2000 09:53 AM
Subject: Re: [oletrucks] Gas Tank Sending Unit
> Bob--
>
> Hi...I don't think the position makes much difference, as far as the
> angle of the arm. I would think that keeping the float about in the
> center of the tank is more important, as the level there will be an
> average level, while it will be going up and down at the sides, front,
> and back of the tank.
>
> I hope you have a new gage to match the new sending unit...or is VDO
> making 30 ohm senders now?
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|