oletrucks
[Top] [All Lists]

Re: [oletrucks] Oil Pressure Problems?

To: oletrucks@autox.team.net
Subject: Re: [oletrucks] Oil Pressure Problems?
From: "Christian Deaton" <gmc594x4@hotmail.com>
Date: Tue, 18 Jan 2000 11:50:17 MST
Terry,
I had just battled a problem similar to yours but a 95 Chevy Z71. My oil 
pressure started reading 60-70 as soon as the truck started and max out at 
80 going down the road. Pulled the oil pressure sending unit to find that my 
truck started at 55-60 and when it is first started and drops to 35-40 
idling jumping back up to 50-60 cruising. You may have a bad sending until 
that cost me about ten bucks. but was hard to get at behind the distributor. 
Hope this will give you another road to travel if you have used have reached 
a dead end.

Christian
59 GMC
Napco

>From: Terry Stellman <STELLMAN@noex.com>
>Reply-To: Terry Stellman <STELLMAN@noex.com>
>To: "Truck List (E-mail)" <oletrucks@autox.team.net>
>Subject: [oletrucks] Oil Pressure Problems?
>Date: Tue, 18 Jan 2000 08:52:54 -0600
>
>I need some expert advice.  I have a 350 4 bolt main that I personally
>rebuilt and installed in my truck.  When I start it ,it has 60# + of oil
>pressure but when I drive it a few miles (4-5) and stop at a red light or
>something the oil pressure will drop to 0-10# when idling.  As soon as I
>accelerate it will shoot up to 40# and settle back to 25-30# when cruising
>down the highway at 2000 rpm.  It had a brand new Melling standard oil pump
>that I have already replaced with another Melling standard oil pump.  I 
>have
>never used one of these before.  In the past I have always used Chevy oil
>pumps and don't remember ever seeing this much pressure fluctuation and
>those low of readings.  Does anybody have any ideas what could be wrong?  
>Is
>this normal for Melling oil pumps?  Should I replace it with a Chevy pump?
>Could there be some other problem?  I Plasticgaged the bearings when I
>assembled it and everything was on the minimum side of the tolerances.  
>Also
>I am running 10W40 oil.  Any help or suggestions would be appreciated.  I
>really am not looking forward to taking the engine out and completely
>rebuilding it again just to try and find this problem.  TIA>
>
>
>Terry Stellman
>1949 3600
>Missouri City, Texas
>
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959


oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>