I'm still trying to figure this out, and maybe I haven't been asking a clear
enough question. I have 2 posts on the back of my water temperature gauge
on the '56. The sending unit has one place to hook up a wire. Question:
How do the wires hook up to the hot and cold side of the gauge? I assume
one goes to the sending unit, and one is either a hot wire or a ground wire?
Again, this is the water temperature gauge.
Thanks for any advice-
Smokey
'50 3600 5-window (mine) & '56 3600 (hers)
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|