I wasn't paying much attention lately about the threads on auto conversion
and the chassis of the AD's. Do i have to remove the stock bell housing
Xmember from the frame or leave it in. I am using Buffalo Eng.'s conversion
plate and it needs motor mounts installed on the plate, which is in the
location of the stock Xmember. I probably can figure it out but don't want
to do trial and error method. Once this is together, i don't want to touch
it again. Well at least until i tear it down for a resto. Thanks again.
Hudak
2-54 3100
57 3100
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|