[oletrucks] Which motor mounts to use in TF

[J & M Street <jmstreet@earthlink.net>]

Hi folks, I'm installing a small block 350 engine in my '55-2 which has
a must. II front end installed and the frame has been boxed. I'm
wondering which motor mounts to use. It has been suggested that I use
the weld in tube cross member type but I'm not sure if it would fit. Any
suggestions? Thanks. Jeff

Jeff Street- Seattle WA. (what's left of it)
'55-2 short/step "Street's rod project"

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959