A hole saw and chisel work great. Had no problems with mine.
Actually, my wife had no problem as she is a cabinet maker.
But I saw it done. That counts, doesn't it?
She put the truck bed in for me from raw material (fir).
Looks really good.
Brad Rusnak
Brad & Karen Rusnak
b_rusnak@telusplanet.net
1949 Chev 1/2 Ton Deluxe Cab
----- Original Message -----
From: <EEHodges@aol.com>
To: <Mikecdk@aol.com>
Cc: <oletrucks@autox.team.net>
Sent: Wednesday, November 24, 1999 5:18 PM
Subject: Re: [oletrucks] Rear bed install
> Countersunk. I found a 1 1/2" wood bit I plan to use. I've seen it
suggested
> to use a hole saw and chisel but that sounds tougher than just the wood
bit.
>
> EEHodges@aol.com
> 48 Chevy 3/4 ton "Rack"
>
> In a message dated 11/23/1999 11:16:07 PM Eastern Standard Time,
> Mikecdk@aol.com writes:
>
> << Well I'm at the point of bolting together the new oak wooden bed in the
> back
> of my 66 stepside. Does anyone happen to know if the offset washers are
> supposed to sit on top of the wood? Or are they to be countersunk so
they
> are flush with the surface? An old piece of plywood was in the truck to
> begin with so I have nothing to go by.
>
> Appreciate any help!
>
> Thanks!
> mike >>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|