In a message dated 11/25/99 8:09:28 PM Pacific Standard Time,
andy51chevy@mindspring.com writes:
> um... Hello,
> Thanks for the info on the C30. That wasn't exactly what I expected. He
> sold it to someone else anyway. Another question (I seem to have a lot of
> 'em) is what about storing parts? Big parts (fenders, hood, etc) take up a
> lot of floor space and I was wondering if any one had found a way to hang
> them from walls without bending or warping them. Any tips on how to hang
> or how not to hang them would be appreciated.
> I just ordered a factor assembly manual, shop manual, and wiring diagram
> from Brother's, so maybe I can actually answer some questions in the near
> future ;-)
>
Geez, you should see my garage, I made a "loft" at on end about 5 feet wide
and 10-12 feet long.
All the walls have some sort of shelf attachemnt that sits about 6foot off
the ground, anywhere from 4 foot deep to 5 foot wide.
I also have a few "shelves" hanging down from the rafters.
There's ALWAYS more room for truck parts.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|