I have an old set of Corvette aluminum valve covers that I would like to use on
my small block. However, the Corvette covers dont have any holes for the pvc
valve or a breather. I was thinking of adding some holes somewhere in the covers
to allow for a pcv valveon one side and a breather/oil filler area on the other
one. Anyone have any advice on doing this? I assume if I do I will need some
baffle on the inside to keep the oil from spashing out the hole. Anyone else
ever done this?
Thanks,
Bob Chansler
'56 3200
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|