No, this tube must be left intact. Remove carefully from block and extract
the whole length through the firewall without crimping.
Grant 50 3100
Jay Duncanson wrote:
> I'm pulling the gauge cluster. Can I just unsolder the copper wire
> at the base of the temp gauge? If so, for reassembly are there any
> considerations other than just soldering it back on?
>
> Jay
> '49 3100
> Jay Duncanson jay@duncanson.com
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|