-----Original Message-----
From: Advdesign1@aol.com <Advdesign1@aol.com>
Date: Wednesday, September 15, 1999 7:34 PM
Subject: Re: [oletrucks] Bare Metal Prep.
> I would also use an etching primer immediately after blasting.
My local PPG rep says that sandblasted metal is etched better than any
etching primer can do so etching primer can be eliminated when priming
sandblasted surfaces.
Bob (Adler) and others, do you agree with this theory? I can see using
etching primer on smooth, bright metal but I hope I didn't screw up by not
using it on sandblasted metal.
Thanks in advance...
Whitney Haist
Orinda, CA
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|