Hey gang,
I could use some input on suspension mods for my old bus. I know it is a
little old for the list, but I am sure some of you will be willing to add
your 2 cents worth.
Subject: 1940 Chev 1-1/2 ton 16 passenger school bus with 133" wheelbase.
It currently has the original drive train. I am looking to do some serious
traveling with this thing and am looking for a smooth and dependable ride.
Option 1: Subframe or switch frames with a one ton step van. This would
give me the modern ride, but I am concerned with the width of the front
suspension. I could widen the fenders to make a better fit.
Option 2: Retain the original drop axle. Change the springs. Convert the
stock hubs to 1 ton disc setup. Narrow a 1 ton rear end and use a 4 link
with airbags.
Option 3: ???
I personally like option two, but have no idea if it is even possible.
Where would I begin to look for a way to convert the front hubs over to the
1 ton disc? Is this something that could be fabricated at a reasonable
cost? I know kits are availible for the half ton trucks so I would assume
technologically it is possible. Also, where would I go to have springs
built?
OK, lets see what you guys can come up with!
Thanks in advance,
Steve
Misc. task force
1940 Bus project
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|