At 08:32 AM 9/6/99 -0400, Bill Bailey wrote:
>Does anyone know if someone manufactures a cutoff tool that runs on
>electricity rather than air. I don't have anywhere to put a compressor.
>Thanks in advance.
Hi Bill
I use a makita 4 inch hand held offset grinder with a cutoff wheel.
works well for cutting out rusted panels.
it is a depressed center and the cutoff wheels are flat, but just turn
the nut over and it works good.
i also used it to cut the wheel areas and tailgate areas on my new
box sides that i had rolled locally.
Floyd
49 3100 deluxe
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|