I am getting ready to re-install the engine in my 60 Apache K20
(someday), and was wondering if you all might know if there is a roller
type throwout bearing available for the 235 L-6? Also, can I use new
flywheel bolts from a V-8 kit - the thread pattern and size look the
same, but I was wondering about clearance. Thanks for your help.
FYI: the 60 Apache has a hydraulic clutch with a slave cylinder; clutch
fork on passenger side; I am upgrading to a 12" 3-finger (Borg & Beck)
clutch from the stock 11" diaphragm...
Tom O (Oregon)
60 Apache K20
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|