In a message dated 8/4/99 7:52:22 PM Pacific Daylight Time,
crankit@fcmail.com writes:
<< Hello, I posted a question to all of you, and only recieved 1
response?...Thanks Keith....I recently dropped off my GMC cab at the acid
dippers, when it is finished, it will have a phosphate coating sprayed thru
and thru. The main question is, what are the steps to take when I get it
back?
Q-1 Do I sand (rough up the surface) and then metal prep, then metal etching
primer?
Q-2 Do I not sand, and apply metal etching primer?
Any body else out there have the correct answer for me so I can purchase the
correct materials before I get it back?
Has any body done this before?
I would really appreciate any comments, because it has been 15 years
awaiting for this "special event", and I want to do it right the first time.
Thanks in advance, Pat
Pat '56 GMC Napc >>
Try this site, the guy knows his stuff.
http://www.autobodystore.com
He sells paint/bodywork equipment, but also offers some good advice on his
message board.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|