In a message dated 8/3/99 8:42:46 PM Pacific Daylight Time,
moneymatters@snet.net writes:
<< I actually have three turnswitch signal switches, two preety used and
one clean one looking brand new. One of the used ones is a Signal stat
900 Sigflare , with 8 wires cut off two gray, 1 blk, 1 red. 1 red with
stripe,and one each blue, yellow, and green.
The other used one zppears to be Yankee with a yellow plastic button on
top? No wires at all
My best lookin g option was in a box, appearly new, but no wiring
instructions. It is a Autolamp 9000 SAE-Q-66, 2 foot wire tail with
flasher and fuseable wire. blk and orange to the flasher unit...one
each yellow,green,brown, red and blue wires. This unit has a green
idicator light for right turns. Has an interesting rubber wheel that
one appears to turn with your thumb in the signal box , wonder what that
is going to do? Did 50's have turn signals or are these add ons after
the fact?
Chet >>
I think I can find the Signal Stat 900 instructions for you, but if you
want to use the other ones, and you have an ohm meter available, I can walk
you through how to figure out which wire goes to what. This is how I figured
out my first Signal Stat, then later, I found the direction sheet.
Let me know.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|