If the pressure plate is the 3 finger style, check that the finger height is
the same on all 3 fingers. I have had the adjustment nuts move on two
rebuilt plates, and considering the work involved in changing them, I will
not use a rebuilt clutch again.
Steve
>I just installed a rebuilt clutch pressure plate, rebuilt disk, new pilot
>bushing and throwout bearing. I had the flywheel resurfaced. The problem
is
>I am getting clutch chatter in first gear when I take off on a hill or
>release the clutch quickly on a flat road. I had this same problem before
I
>replaced the clutch. The 216 engine has a slight rear main seal leak,
however
>I did not see any indication of oil getting onto the clutch surface. Any
>ideas?
>
>Thanks,
>Pete
>"Ole Betsy"
>'53 - 3600
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|