I've been thoroughly checking my almost finished truck for quirks and
put about 150 miles on it in the last couple days. I had the front end
aligned yesterday. I used a different axle and spindles than I had
before with new king pins as well as new everything else. I brought it
to a alignment shop capable of bending the axle to adjust camber if
necessary. The alignment shop said everything was in spec and charged
me $40 to take it for a ride. I now notice on right hand turns there is
a moment of slight over steer, not real bad but enough to need slight
correction during the turn. Left turns seem fine. Any ideas what would
cause this or how to correct it?
Thanks, Grant 50 3100
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|