oletrucks
[Top] [All Lists]

Re: [oletrucks] Rocker Arm Studs

To: "Kevin Lake" <lakek@oit.edu>, <jvanho01@tir.com>,
Subject: Re: [oletrucks] Rocker Arm Studs
From: jvanho01@tir.com
Date: Thu, 27 May 1999 06:25:55 -0400
Thanks Kevin, I already checked with Kanter and they don't have.  I am starting
with some of the local hot rod shops in the area, with no success so far.  What
year(s) was the 389ci Pontiac engine?

Jim V.

At 10:25 PM 5/26/99 Wednesday -0700, Kevin Lake wrote:
>Check with Kanter Automotive, sorry I don't have an address because all of
>my stuff is packed for moving.  Kanter carries a lot of parts and rebuild
>stuff for the Pontiac/GMC motors.  You might also check with the Pontiac
>specialty places, they should use the same rocker arm studs.  You might
>also check the Hot Rod shops, I think the 389ci Pontiac may (not sure) use
>the same studs.  Good luck.
>
>Kevin Lake
>56 GMC Suburban/napco
>
>----------
>> From: jvanho01@tir.com
>> To: oletrucks <oletrucks@autox.team.net>
>> Subject: [oletrucks] Rocker Arm Studs
>> Date: Wednesday, May 26, 1999 6:22 PM
>> 
>> I have checked just about everywhere I know to check and have not been
>> successful in locating replacement rocker arm studs for my 58 V8 GMC
>> engine.  These would be screw in type rather than pressed in.  Also, they
>> are hollow from the bottom side with a side hole to oil the rocker arm.
>> Any thoughts or help would be greatly appreciated.
>> 
>> Thanks,
>> 
>> 
>> Jim V. - '58 GMC Suburban Carrier Pickup V8 Automatic
>> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959


<Prev in Thread] Current Thread [Next in Thread>