In a message dated 05/14/99 09:35:35 PM Eastern Daylight Time,
rjj0msj@ix.netcom.com writes:
<< You simply push two bolts through the
slots in the puller, then thread them into the holes in the steering wheel.
Next, thread the large center bolt through the center hole in the puller, >>
Chase threads in steering wheel before tightening screws. Rust may make the
puller screws bind and break in your steering wheel. Put a 1/2-20
rethreading die on threads before distorting them with the force screw. I've
seen many of these threads rendered hopeless which kills the whole worm shaft.
Bob ADler
|