They should be different angles on the tube going in from the left and the
right, and they should both be a stepped bore. Mine has a little tube that
is attached to the back side of the cylinder, and gets it extended out past
the obstructions. I have been told that you must salvage the extension
tube from your original cylinders and install them on the new ones. Good
luck.
Kevin Lake
56 GMC Suburban/napco
----------
> From: G. StPierre <gstpierr@u.washington.edu>
> To: STMSymank@aol.com
> Cc: oletrucks@autox.team.net
> Subject: Re: [oletrucks] Napco 1/2 ton wheel cylinders
> Date: Tuesday, April 27, 1999 8:39 AM
>
> Howdy...just curious. Is it possible to swap the right side for the left
> side on these? Also, I have heard that these wheel cylinders have a
> stepped bore and that the 2WD cylinders are different. Is this true?
>
> Regards,
>
> Greg St. Pierre
> '55 Task 4x4ce
>
>
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|