Claude
Several years I installed an open drive shaft rear end in my 52 Chev 1300
and the instructions that came with the mounting kit called for the face of
the universal joint attachment point on the pinion shaft to be set at 3
degrees above horizontal. in other words if you put the pinion shaft
comming out of the differential so that it is level it has to be moved up to
3 degrees off of horizontal. This is with the truck sitting in it's normal
running position ie. wheels on the ground.
Hope this helps
Mac
52 Chev 1300
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|