I'm having a time with my gas gauge. I've recently installed a new sending
unit, with 1 wire going to the gauge. The other wire to the gauge, of
course, is a hot wire. When I hook them up I get nothing.
I bought the gauge this morning, and was told that if my ohm meter showed
continuity between the terminals, it was good. It does. I am using a 12 to
6 volt reducer. I have taken the sending unit out of the tank, and have
moved the float up and down, but the gauge stays on empty.
Anyone had a similar problem that they were able to figure out?
Thanks in advance-
Smokey
'50 3600 5-window
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|