Andy,
Got it done with the thin piping out. A bit fiddly but due to the
application of a bit of silicon here and there, it is on. The thin
side out minimized the visual impact.
Now to complete the shocks and suspension before Sunday!
Mark
Mark Darley
markdarley@mac.com
Mobile Phone 415 310 5252
On May 13, 2010, at 6:11 PM, andy preston wrote:
> Mark, I'd think that the fat side faces out, but I don't remember
> there
> being a fat or thin side. It's very difficult to get to the piping
> to stay
> in place on the back of the grille prior to installing the grille
> on the
> car. On mine I attached the piping to the back of the grille and
> held it in
> place with blue masking tape spaced 1" apart. I used clear
> silicone sealer
> to attach the piping to the back of the grille in the 1" spaces.
> When the
> silicone had set, I removed the tape and applied more silicone
> sealant where
> the tape had been. Even then you have to be very careful to
> ensure that it
> doesn't fall off.
>
>
>
> Good luck
>
>
>
> Andy
> _______________________________________________
> Nobbc mailing list
> Nobbc@autox.team.net
> http://autox.team.net/mailman/listinfo/nobbc
_______________________________________________
Nobbc mailing list
Nobbc@autox.team.net
http://autox.team.net/mailman/listinfo/nobbc
|