Bill et al,
A few years ago I had a machine shop do it for me. I believe
they used a large lathe. The dimension is 3 11/16" My idea was to
take out as litle as possible yet have them still fit around those
Morris front hubs. I suspect 3 3/4" would be OK, though I did not
want to unncecessarily weaken the wheel.
Cheers,
Dave K.
----------------------------------------------------------
>Dear Listers: I just shipped some Chevy Vega wheels to another lister and he
>is asking how to make the center hole bigger to fit on a Morris Minor. Any
>suggestions on the correct hole diameter and preferred hole enlargement
>method? Thanks for your help. ---Bill Langdell, Sunnyvale "57 Minor 1000
Convertible.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morris
|