Here is a Clutch summary
+4 Clutch Info
From: Bob Bowie in Maine
Last update: November 25, 2005
Bob Bowie in Maine wrote up some of the info he found out about the
clutches for the +4s while restoring his SS.
Flywheel
The flywheel is same as TR3/4 for all plus 4 years, it has TWO dowel pins
and is about 11.25 inches diamter. it has the sweat on ring gear The
flywheel is 1 and 7/16 thick at the edge. This includes the ring gear.
Number of bolts that hold the clutch pressure plate to the flywheel 6
Sources
Flywheels are not listed as available, ring gears had moss and the
Roadster factory as sources, some racing outfits offer alloy flywheels.
Mistakes
The TR4a flywheel is smaller at 11 inch diameter and has three pin
locaters, there is a an MGB pressure plate fix with the 8.5 inch clutch
plate from a TR4A/TR6 that requires a new hole in the throwout to give
proper throw out clearance (see Morgan Bedside Reader-Greg Solow made
this conversion) Clutch Plate:
Originally Borg and Beck 9 inch single dry plate the clutch plate is 9
inch diameter, same as TR4 (actually TR3 from 1955 on at least)
Girling application book: The driven plate is 85824/00RP
Driven plate:
Borg & Beck 50052, Delphi # LL50J
Automotive products HB9715Q
BAP-GEON New part number 45692/15 Rebuilt part number 47344
(by the way lists the same part number for tr3/4 and Austin Healey 100/4
to 1956, 100/6 - 1957-?1962 (I thought they changed to 3000 in 59!) also
found CD344
Sources:
Most all vendors
Mistakes
The TR4a clutch disc is smaller than the TR4! dont use it in a standard
Morgan setup. (Greg Solow and Fred Sisson can tell you how to use one)
Pressure Plate:
The Pressure plate is same as early 100-4 Austin-Healey and goes into
early 100-6 series as well.
May be Pressure plate: Borg & Beck # 45692/15 and/or 34H44 HA3359Q
(?Automotive products number) also reference CC344 found
Sources
Linda at Morgan Spares does have these in Stock Pressure Plate 100-372
Moss may have them
Melvyn Rutter rebuilds them
They have been made by Automotive Products plc of Leamington Spa,
England.
Mistakes:
Dont use a Triumph Pressure plate for TR engine Morgan as the throw out
bearing will hit teeth.
I have a note that mentions another source also for the throw out bearing
early JAg xk120?
Summary
If you measure your flywheel and its just 11 inches consider the Sisson
fix, or if thats what all you can find. If you want original, your going
to need a TR3/4 two dowel type flywheel 11 inches, a good machinest can
also fix this issue. The size of the flywheel and clutch assembly got
smaller at the TR4a, but not for Morgans. Now will the M418G (tr4 type)
starter fit TR3 flywheel. Bob Bowie
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|