Hi, another odd question,
are the tunnel cover attachments and prop shaft cover attachments
screw or lift a dots fasteners.
I have found the lift a dots on bits of the old floorboard but and not
sure if they were the primary way it was held down,
its seems logocal that the lift a dot or maybe every other hole was a
lift a dot and that they screw into the floorboard, thus holding down the
metal cover and
at the same time allowing a fitting for the interior pad covering .
any ideas out there?
thanks
Bob Bowie in Maine
63 SS 5381
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morgans
|