At 11:56 PM -0400 8/3/02, Robin & Ron wrote:
>
> Under the outer grease seal, between the outer
>plate and the brake backing plate, and between the backing plate and the
>bearing plate seem like 3 logical spots, but if one also goes between bearing
>plate and shims, that would make 4 per side. Also if one goes there, why not
>another one or two as additional shims if needed? Wazzup?
Ron,
I did this about a year ago. You are correct, 1 gasket between the
retaining plate and the break backing plate. 1 between the backing
plate and the outer retaining plate, and 1 between the outer plate
and the retainer. This according to Morgan Spares catalog.
Nelson
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morgans
|