Copper gaskets- you specify thickness. They keep your pattern on computer so
you can re-order (or share the design) anytime in the future.
They have my modified Willment head for EnFo 100E if anybody needs one
(grin...)
Forgot the pattern charge, but I think I paid around $35.00 for gaskets for
the EnFo.
fred sisson
+++++++++++
On solid copper head gaskets
In the engine section, I mention SOLID COPPER HEAD GASKETS from
Accutronics. sealed with Toyota Black Silicone part #0029500102.
I have had some experience with this since I wrote the book... and it works
like a charm. Be neat about coating the gasket- not too thick. It separates
clean when disassembled and seems to be quite easy to remove from the
block/head in prep for re-installation. I was impressed. I was sealing a very
old aluminum head with a bit of pitting on the surface. I did not want to
have the head surfaced planed if possible- just to preserve it. Under hard
use & a couple of overheating episodes- there was never a problem with the
seal.
More on solid copper head gasketsb&
Accutronix is now Copper Gaskets. Nice descriptive nameb& New address too:
Copper Gaskets
9230 N 14th Avenue #2
Phoenix, AZ 85021
Ph: 6o2 861 5096
///
/// morgans@autox.team.net mailing list
///
|