For anyone who's interested, this wire list should work for almost any Series
II-V 4/4. I pulled all the harness apart and measured how much of what kind
of wire is in it, and how many connectors. Here they are: (Numbers are in
feet, letters following are Lucas color code, big wires are 12-14g, all
others 16-18g.)
Gen to reg 6' Y big
6' YG big
Reg to ign 8' NU big
ign to fuse 4.5' W-LG
Solenoid to fuse
and ammeter 6' N big
ign to solenoid 4' WR
ign to reg 4' Y
ign to coil 8' W
coil to distr 2' WB
reg to amm 6' NW big
lite sw to dimmer 6' U big
fuel ga. to
rear harness 6' GB
fuse to brake
lite switch 5' G
brake lite to
rear harness 7' GP
fuse to flasher 4' G
flasher to dash
telltale 2' LG
dash telltale to
gnd 3' B
flasher to signal
switch 4' G
fuel ga to H2O ga 3.5' G
H20 ga to sender 7' GB
turn sig sw to
LH lites 12' GW
turn sig sw to
RH lites 10' GR (RHD car)
lite sw to sidelamp 20' R
horn to horn 3' P
Dash Grounds 18' B
horn to horn 3' PB
horn sw to horn 4' NB
fuse to horn 4' NG
fuse to stop lamp
sw 3' G
dimmer to lo beams 16' UR
dimmer to Hi beams 22' UW (you figger it out)
panel lite sw to panel
lites 8' to 5 lights
lite sw to lic. plate 12' R
lite sw to tail lites 12' R
lite sw to panel lite
switch 4' R
fuse to wiper motor 6' G
wiper motor to wiper
sw 6' BG
There are 58 1/4" female blade connectors, 5 3/8" blade connectors, and 12
circular lugs, along with 24 bullet-type butt connectors and 10 bullet ends.
The wires run everywhere, sometimes with 3 times as much as you need just so
it can run along with another wire that has nothing to do with it for ease of
factory installation.
I'm gonna see what this will cost and compare to a made harness. Pictures at
11.
Lannis
|