In a message dated 97-10-28 17:41:34 EST, zehrinwa@UMDNJ.EDU writes:
<< In regards to Joe DeLuca's comments in the 4/4 vrs. +4 issue: correct me
if
I'm wrong but... The lower stance of the 4/4 is due, in part, to the
placement of the rear axle ABOVE the frame rails (allowed, I gather from
Joe, because the ford mill is shorter than the TR mill). Is this true? Is
the rear axle on the typical +4 located underneath the frame rails? I >>
I have never seen a morgan with the rear axle below the frame rails.
Lance K. Lipscomb
81 Plus 8 - axle definately above the frame rails.
|