Jerry Murphy wrote:
> Snip The rake of the seatback is set by an ash
> crossbar about 5/4 X 2 which traverses the car at the heiight of the
> seatback and which is attached to the body side panels with two part steel
> brackets. These brackets have about a three inch slot in the movable part.
> The fixed part is screwed to the side panels. It has a stud which goes
> through the slot in the movable crossbar bracket and a wingnut to clamp the
> crossbar in place. Pretty primitive, and the wingnut chews up the side
> panels of the seatback.
> Jerry MurphySnip--------------------------------
Little trick here for tall Morgan owners.
The bracket that Jerry mentions with the three inch slot, has the leg for the
moveable ash cross bar in the middle of that three inch slot. Cut the leg off
and
weld it on to the end of the part with the slot. This allows the seat back to
be
pushed back an additional inch and a half.
Bob Nogueira
|