Hey guys,
Our team is looking into the possibility of welding 4130 to
1020. I have heard that this type of thing is possible,
however I'm trying to find out which filler rod will work
best for this type of application. Any ideas or
suggestions?
By the way, thanks to all of you who responded to my
earlier question about post weld heat treating 4130
steel...you're responses were all very helpful.
Thanks,
Sarah Paterson, Team Manager
Midwest Mini Baja 2004
University of Windsor
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mini-baja
|