Can't help on the pulley, except to say that doing a trial fit of the fan
belt will tell you which way round it goes, as with two different sizes the
wrong one, when it is in line with the crank and alternator pulleys, will
either be too short or too long. But I was under the impression that all
the pulleys were one-piece, regardless of how many 'slots' they had.
The pump should have a flange with perhaps eight tapped holes on the face,
four at one distance from the centre and four at another. I've just changed
my water pump and the pulley simply fits over the flange such that you can
see the four appropriate (probably the outer ones) holes are visible through
the pulley holes, I just positioned the flange with one of the holes at the
top, then fitted the pulley over it also with one of the holes at the top.
If you don't get it exact it should be close enough to get a small probe
through both holes to line them up for the bolts. My pulley say on the
flange quite happily, while I offered-up the fan with bolts, locktabs,
washers, spaces, and rubber grommets (for metal fans). If your is supposed
to be multi-part then you may have to fit the pulley over the fan bolts and
get the alignment of the top bolt with a top hole as close as possible as
you bring the fan etc. to the flange. If you have a long-nosed pump i.e. a
deep pulley it might be tricky getting fingers in the back to hold the pump
still while you turn the fan etc. to find the holes. If your pump has a
drain hole underneath you might be able to press a soft drift up through
there to hold the shaft while you do it.
PaulH.
----- Original Message -----
> In replacing the water pump on my 1980 MGB LE I discovered the pulley
> consists
> of three parts: a large and a small pulley and a ring. In my haste I
> forgot
> the correct order. Any of you with a RBB can do me a huge favor by looking
> at
> the configuration on your car and let me know the correct orientation.
> Does
> the smaller pulley go on the inside closer to the engine? Secondly, is
> there
> some simple method for lining up the 4 bolt holes thru the pulley so they
> properly align with the holes on the water pump
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|