I am looking for a master cylinder hone as I start the rebuild of my 64B
hydraulics. Any suggestions or sources? I had one that worked on wheel
cylinders but the bore is wider so those are easy to find. The smallest I see
listed, at least at NAPA, is 7/8" and larger bores. It looks like the bore, at
least on a spare one (brake, but it looks like clutch may be similar or same)
that I have, is about >" (approximate, I used a tape measure).
David Councill
64 B
67 BGT
72 B
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|