I'm posting this in a few different places, so please excuse any duplicates.
For those people who may have an MGA chassis or frame with body off,
can you measure the inside and outside width of the frame where the
rear bumper brackets attach? I would like measurements from two or
three different frames to verify consistency (or amount of possible
variation). I need this for a wheel chair lift I'm working on that
will attach to the frame similar to a trailer hitch bracket.
Barney Gaylord
1958 MGA with an attitude
http://MGAguru.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|