I used a 33 mm socket. I also had to use an impact wrench and hammer on it
for about 15 minutes before they broke. I got my wrench and socket at
Harbor Freight.
Merl Rosenthal
----- Original Message -----
From: "Rick Lindsay" <rolindsay@yahoo.com>
To: "MGS" <mgs@autox.team.net>
Sent: Sunday, June 01, 2008 12:02 PM
Subject: [Mgs] MGB rear axle nut
> Hey Gang,
>
> Some time ago I asked the size of the thin-wall socket
> needed to remove the axle nut on the MGB's rear axle.
> I believe that the size is 1-5/8" but I need to verify
> that before buying a socket. Is that size correct? I
> need to remove the hub to replace the oil seal (then
> rebuild the brakes).
>
> Second question; anyone know of a source for these
> sockets? I have looked in all the usual places but I
> have not found the 1-5/8" size.
>
> All advice is appreciated.
>
> rick
> '08 M-B C300
> '03 L-R Discovery
> '96 BMW 740iL
> '79 Ferrari 308GTB
> '70 MGB Split-bumper Tourer
> '61 M-B 180b Saloon
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as mvrose@charter.net
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|